NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 527
Logging Location Codes
TCP Logging Locations
ACTION: Capture data traffic includingoffending fin and following data
packet using tracing or a line analyzer. Report an error against the
remote implementation.
MESSAGE: None
12601 CLAS0003 CAUSE: A packet was received which contained a TCP header with a
max tpdu option which had an incorrect option length in the option
length field.
ACTION: Capture data traffic including offending data packet using
tracing or a line analyzer. Report an error against the remote
implementation.
MESSAGE: None
12701 CLAS0005 CAUSE: TCP SIP sent out a reset for a packet with the ack flag set that
was received on a socket in listen state.
ACTION: Informative message. No action required.
MESSAGE: None
12702 CLAS0005 CAUSE: TCP SIP tossed a packet with the ack and syn flags set that
was received for a socket in the listen state.
ACTION: Informative message. No action required.
MESSAGE: None
12801 CLAS0005 CAUSE: Inbound packet received for a closed (not opened) sap, so the
TCP SIP will send a reset.
ACTION: Informative message. No action required. Start service or
open correct SAP if necessary. PARM is SAP for which packet is bound.
MESSAGE: None
13001 CLAS0003 CAUSE: IPC called tcp_receive_reply, but TCP did not have any
record of data outstanding to IPC.
ACTION: Submit an SR.
MESSAGE: None
13101 CLAS0003 CAUSE: IPC called tcp_receive_reply, but TCP data indicates that
IPC should not be in data receptive state.
ACTION: Submit an SR.
MESSAGE: None
13201 CLAS0005 CAUSE: An attempt was made to start a TCP connection; however, the
protocol was not active (i.e., was stopped).
ACTION: Informative message. Start the network if needed.