NS3000/iX Error Messages Reference Manual (36923-90041)

494 Chapter19
Logging Location Codes
Remote Link Manager Logging Location Codes
MESSAGE: None
115 CLAS0003 CAUSE: RLM could not deconfigure AFCP protocol module (PARM =
status returned by 'mcm_module_config').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
116 CLAS0003 CAUSE: RLM could not release plabel for 'remote_link_manager'
(PARM = status returned by 'hprelsysplabel').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
117 CLAS0003 CAUSE: RLM could not delete the RLM’s entry from the CM port
dictionary (PARM = status returned by 'dict_delete').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
118 CLAS0002 CAUSE: RLM could not create the outbound buffer pool (PARM =
status returned by 'bmgr_create_pool').
ACTION: Check configuration file for excessive buffer configuration.
Reduce the number of buffers if possible. If no problems are found, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
119 CLAS0003 CAUSE: RLM could not reset subqueue mask (PARM = status returned
by 'change_subqueue').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
120 CLAS0001 CAUSE: RLM could not update port dictionary (PARM = status
returned by 'dict_update').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
121 CLAS0001 CAUSE: RLM could not update port dictionary (PARM = status
returned by 'dict_update').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
122 CLAS0003 CAUSE: RLM could not delete the outbound buffer pool (PARM =
status returned by 'bmgr_delete_pool').
ACTION: See Appendix A, “Submitting an SR,” of this manual.