NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 493
Logging Location Codes
Remote Link Manager Logging Location Codes
MESSAGE: None
107 CLAS0001 CAUSE: Error encountered while receiving information from RLM
Server (PARM = status returned by 'extend_receive').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
108 CLAS0001 CAUSE: Message received on process port if not the expected type.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
109 CLAS0002 CAUSE: Link buffer size is too small.
ACTION: Check X.25 and DTC Link configuration. If no problems are
found, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
110 CLAS0003 CAUSE: Could not open the file NMCONFIG.PUB.SYS (PARM = status
returned by 'nmconfopen').
ACTION: Check the nmconfig.pub.sys with the program 'FSCHECK'. If
no obvious problem is found, see Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: None
111 CLAS0003 CAUSE: Could not read the Node Name from NMCONFIG.PUB.SYS
(PARM = status returned by 'nmconfgetdata').
ACTION: Add nodename to configuration.
MESSAGE: None
112 CLAS0003 CAUSE: RLM could not close NMCONFIG.PUB.SYS (PARM = status
returned by 'nmconfclose').
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
113 CLAS0002 CAUSE: Could not create the RLM’s inbound buffer pool (PARM =
status returned from 'bmgr_create_pool').
ACTION: Check configuration file for excessive buffer configuration.
Reduce the number of buffers if possible. If no problems are found, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
114 CLAS0002 CAUSE: Could not release the RLM’s inbound buffer pool (PARM =
status returned by 'bmgr_delete_pool').
ACTION: See Appendix A, “Submitting an SR,” of this manual.