NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 489
Logging Location Codes
Remote Link Manager Logging Location Codes
MESSAGE: None
59 CLAS0002 CAUSE: Could not release timer.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
60 CLAS0002 CAUSE: Invalid message received for current state.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
61 CLAS0003 CAUSE: Link has gone down.
ACTION: Run appropriate diagnostics. If no error is found, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
62 CLAS0001 CAUSE: Internal State Error.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
63 CLAS0002 CAUSE: Link State Error.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
64 CLAS0002 CAUSE: Subsystem (NS Transport) specified an invalid link.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
65 CLAS0005 CAUSE: DTC link was closed successfully.
ACTION: None. (This is just an informative log.)
MESSAGE: None
66 CLAS0005 CAUSE: DTC link was closed while it was in a bad state.
ACTION: Check status of X.25 card on DTC.
MESSAGE: None
67 CLAS0005 CAUSE: DTC link was opened successfully.
ACTION: None.
MESSAGE: None
68 CLAS0005 CAUSE: HP 3000 link failure occurred while attempting to shut down
the DTC link.
ACTION: Check status of LAN hardware.