NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 485
Logging Location Codes
Remote Link Manager Logging Location Codes
MESSAGE: None
19 CLAS0002 CAUSE: RLM could not write outbound packet to buffer.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
20 CLAS0002 CAUSE: RLM could not read buffer containing inbound packet.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
21 CLAS0001 CAUSE: Mismatch in states between the DTC and the HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
22 CLAS0002 CAUSE: Mismatch in states between DTC and HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
23 CLAS0001 CAUSE: Mismatch in states between the DTC and the HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
24 CLAS0001 CAUSE: Mismatch in states between the DTC and the HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
25 CLAS0003 CAUSE: DTC returned bad status during link shutdown (PARM =
status returned by DTC).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
26 CLAS0002 CAUSE: Subsystem (NS Transport) specified invalid link.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
27 CLAS0003 CAUSE: Subsystem (NS Transport) attempted to connect X.25 card
that was in a bad state.