NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 483
Logging Location Codes
Remote Link Manager Logging Location Codes
Remote Link Manager Logging Location
Codes
MESSAGE: None
1 CLAS0001 CAUSE: RLM’s data structures are corrupted.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
3 CLAS0002 CAUSE: Send_msg procedure returned a bad status to the RLM.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
4 CLAS0002 CAUSE: Link Error occurred in unexpected state.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
5 CLAS0002 CAUSE: RLM could not rendezvous (‘bind’) with the MCM.
ACTION: Check the LAN hardware on the HP 3000. If no problem is
found, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
6 CLAS0001 CAUSE: Internal state mismatch within the RLM module.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
7 CLAS0003 CAUSE: RLM is out of internal resources.
ACTION: The operator may be attempting to bring up more than the
maximum supported DTC links. If not, then see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: None
8 CLAS0002 CAUSE: Either the RLM or code that it invoked encountered an
unexpected trap.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
9 CLAS0002 CAUSE: RLM could not get a buffer to send an outbound packet (PARM
= Status returned by 'bmgr_get_buffer').
ACTION: See Appendix A, “Submitting an SR,” of this manual.