NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 467
Logging Location Codes
Probe Logging Location Codes
MESSAGE: None
48 CLAS0002 CAUSE: Attempt to add PROBE to the mapping table during INIT
message failed (PARM = mapping error code).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
49 CLAS0002 CAUSE: Could not delete the PROBE entity from the mapping table in
a terminate sequence (PARM = mapping error code).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
52 CLAS0002 CAUSE: Invalid device information in Probe’s data area.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
53 CLAS0002 CAUSE: Invalid device information in Probe’s data area.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
55 CLAS0002 CAUSE: Attempt to add MAP address failed.
ACTION: Increase the maximum number of nodes in the LAN 802.3 NI
screen in NMMGR. If error recurs, then see Appendix A, “Submitting
an SR,” of this manual.