NS3000/iX Error Messages Reference Manual (36923-90041)

456 Chapter19
Logging Location Codes
NI Logging Location Codes
MESSAGE: None
25 CLAS0002 CAUSE: The protocol attempted to send data when no devices were
active (PARM = Protocol ID).
ACTION: Error should be preceded by other errors or a DELLINK
message. If not, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
28 CLAS0004 CAUSE: Network Interface Started (PARM = NI port data address).
ACTION: None.
MESSAGE: None
29 CLAS0004 CAUSE: Network Interface Stopped (PARM = NI port data address).
ACTION: None.
MESSAGE: None
30 CLAS0002 CAUSE: Trouble starting the idle device timer of the NI (PARM =
status from get_timer).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
44 CLAS0002 CAUSE: While trying to send a connect request to a driver, a send_msg
failed (PARM = status from send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
46 CLAS0002 CAUSE: CP asked NI to disconnect a device which NI could not find in
its device table (PARM = connect ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
48 CLAS0002 CAUSE: While trying to send a disconnect request to a driver, a
send_msg failed (PARM = status from send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
49 CLAS0002 CAUSE: CP asked NI to connect a device which NI could not find in its
device table (PARM = link ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
51 CLAS0002 CAUSE: After receiving a connect confirmation event from a driver, NI
could not find the protocol for that device type, either X.25 or SNA, in
its PID table.