NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 455
Logging Location Codes
NI Logging Location Codes
MESSAGE: None
14 CLAS0002 CAUSE: On arrival of inbound data, a send_msg to the upper layer
protocol failed (PARM = status from send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
15 CLAS0002 CAUSE: The NI received an inbound data message from a device that is
not in the device table for this NI (PARM = LDEV).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
18 CLAS0002 CAUSE: A bad or unexpected message was received by the NI (PARM =
Message Function Code).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
19 CLAS0002 CAUSE: While trying to send outbound loopback data back, a
send_msg failed (PARM = status from send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
21 CLAS0002 CAUSE: While trying to send outbound data to a router driver via
DC/LDM, a send_msg failed (PARM = status from send_msg).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
22 CLAS0002 CAUSE: Transport sent outbound data to NI for a Protocol ID which
has no match in the PID table for this NI (PARM = Protocol ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
23 CLAS0003 CAUSE: While attempting to send outbound data, NI discovered the
route ID in the message was out of date, so the outbound packet was
discarded (PARM = route ID from route table).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
24 CLAS0002 CAUSE: A protocol other than PROBE attempted to send a multicast
packet, disallowed by the NI (PARM = Protocol ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.