NS3000/iX Error Messages Reference Manual (36923-90041)
454 Chapter19
Logging Location Codes
NI Logging Location Codes
NI Logging Location Codes
MESSAGE: None
1 CLAS0005 CAUSE: Device was idle for configured Idle Timeout and timer was
enabled for this device. Device will be disconnected (PARM = device
ldev).
ACTION: None.
MESSAGE: None
4 CLAS0002 CAUSE: Protocol ID in Protocol Stop message was not found in NI’s
PID table (PARM = Protocol ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
5 CLAS0002 CAUSE: PID table is too small for the number of protocols being started
for this NI (PARM = Protocol ID which could not be started).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
6 CLAS0002 CAUSE: CP asked NI to stop a device which NI could not locate in its
device tables (PARM = device ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
7 CLAS0002 CAUSE: Device table is too small for the number of devices being
started for this NI, or a device was started twice by CP (PARM = Device
ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
11 CLAS0002 CAUSE: NI received data on a Protocol ID which has no match in PID
table (PARM = Protocol ID).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
13 CLAS0002 CAUSE: Dial Protocol owns the device, but another protocol was sent
data from the remote node (PARM = Violating Protocol ID).
ACTION: If this happens frequently, carefully check the configurations
on both the local and remote systems. See Appendix A, “Submitting an
SR,” of this manual.