NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 451
Logging Location Codes
NETIPC Logging Location Codes
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal error.
26 CLAS0000 CAUSE: Error in call to dict_find.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal error.
27 CLAS0000 CAUSE: Unable to create socket record.
ACTION: This is typically not an error condition. A total of at least 8000
socket records can be opened simultaneously on your system. If you do
believe that there are not that many sockets opened then submit an SR.
Otherwise run your application when there are fewer NETIPC
applications active on your system.
MESSAGE: Internal error.
30 CLAS0000 CAUSE: Error in call to dict_find.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal error.
32 CLAS0000 CAUSE: Failed to allocate an address.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
33 CLAS0000 CAUSE: Protocol module error.
ACTION: Verify the protocol module is active. See Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: Internal error.
34 CLAS0000 CAUSE: Table Manager error.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Internal error.
35 CLAS0000 CAUSE: Failure in freezing the GSXDS. The GSXDS is a data structure
internal to the NETIPC Subsystem.
ACTION: Check the memory allocation on your system and see
Appendix A, “Submitting an SR,” of this manual if an SR is needed.
MESSAGE: Internal error.
36 CLAS0000 CAUSE: Failure in creating new process.
ACTION: Check the files in NET.SYS to ensure that all networking
programs are installed. For example, make sure that
PT2PNSTN.NET.SYS exists. If files are ok, then see Appendix A,
“Submitting an SR,” of this manual to submit an SR.