NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 3 45
NS/NFTERR and NS/NFTWARN Messages
MESSAGE: UNABLE TO RESTART TRANSFER
62 CAUSE: NFT attempted to restart a generic transfer and was unable to
open the generic listf file, i.e., the file which contains the list of files
to be transferred. This would occur if the file is opened exclusively or
has been purged.
ACTION: Make sure that the generic listf file (GENSETn) exists in
the producer’s group and account and is not accessed exclusively.
MESSAGE: SOURCE AND TARGET CHECKPOINTS DO NOT MATCH.
63 CAUSE: A restart has been attempted and the producer and consumer
checkpoints do not match. The checkpoint restart file has been
corrupted, or a serious internal NFT error has occurred.
ACTION: Restart the transfer from scratch. If the problem persists, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: UNABLE TO INITIATE CHECKPOINTING.
64 CAUSE: This warning is issued for any one of the following reasons:
• A checkpoint/restart file cannot be opened or created.
• The restart ID file cannot be opened or created.
• The information cannot be written to the checkpoint/restart file, the
generic listf file, or the restart ID file.
• Checkpointing is being attempted on a circular file, a message file, or
a variable length record file in interchange mode.
• Checkpointing is being attempted to a node which does not support
checkpointing.
ACTION: After the warning is issued, the file transfer will continue
with no checkpointing taking place. You may wish to abort the transfer.
MESSAGE: CHECKPOINTING WILL NOT BE DONE FOR LOCAL
TRANSFERS.
65 CAUSE: Checkpointing has been specified for a transfer for which the
producer and consumer environments are equivalent, i.e., their group,
account, and node name are the same.
ACTION: Transfer will continue with no checkpointing. You may wish
to abort the transfer.
MESSAGE: FOUND END OF FILE MARK IN TARGET FILE, TRANSFER
STOPPED.
66 CAUSE: Use of the FSIZE option has resulted in a target file too small
to hold the source file. After the target file is full, the transfer is
stopped.
ACTION: None.