NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 447
Logging Location Codes
Net Timers Logging Location Codes
ACTION: Depending on the PARM value, your system load, and your
current configuration, it is possible too much resident memory is
already in use on your system to support the number of timers required
by maximum the number of TCP connections currently configured in
NMMGR, and thus the required PDA size. If this seems likely, you
might try starting your network sooner after system startup, or
possibly reducing the number of TCP connections configured. If
necessary, submit an SR.
MESSAGE: Find Procedure Failed
4360 CLAS0002 CAUSE: During startup, when attempting to load the address of an
NL.PUB.SYS procedure to service the Net Timers port, the system
routine Hpgetsysplabel reported an error trying to locate the system
routine nettmr_ics_server. This procedure is required so the
system will know who to call to process timeout messages arriving at
the port (PARM = status from Hpgetsysplabel).
ACTION: Net Timers failed to start; instead it cleaned up after itself
and reported an error. If you just installed a new release of the
Transport subsystem, possibly the installation was incorrect,
incomplete, or corrupted. There is also a remote possibility the system
has run out of room for dynamically- loaded procedures. If necessary,
submit an SR.
MESSAGE: Create Port Failed
4380 CLAS0002 CAUSE: During startup, while attempting to create a message port to
receive system-timer timeout messages, the system routine
Create_port failed. The port is needed as a destination for timeout
messages for the system timers which drive Net Timers (PARM =
status from Create_port).
ACTION: Net Timers failed to start; instead it cleaned up after itself
and reported an error. If your system is heavily loaded, it is possible the
system has run out of ports; if you think this is the case, you might try
reducing system load, however a significant reduction would be needed
to allow all of Transport to start up. If necessary, submit an SR.
MESSAGE: Cannot disown port
4400 CLAS0002 CAUSE: During startup, after successful creation of a port for Net
Timers, the system routine Port_control reported an error trying to
release CP’s ownership of the port. Port ownership must be released in
case a different process deletes the Net Timers port later (PARM =
status from Port_control).
ACTION: Net Timers failed to start; instead it cleaned up after itself
and reported an error. Submit an SR.