NS3000/iX Error Messages Reference Manual (36923-90041)

444 Chapter19
Logging Location Codes
Net Timers Logging Location Codes
MESSAGE: Cannot unfreeze memory
3360 CLAS0002 CAUSE: While attempting to unfreeze a caller- specified statistics
buffer previously frozen into memory, the system routine Unfreeze
reported an error. Unfreezing is necessary to avoid memory
fragmentation over time (PARM = status from Unfreeze).
ACTION: Net Timers will continue to run as normal, though no
statistics data was obtained, and some memory space may be lost until
the next system startup. Submit an SR.
MESSAGE: Not up for processing
3380 CLAS0002 CAUSE: An attempt was made to perform a Net Timers control
operation during Net Timers startup, or during or after shutdown.
Control operations cannot be performed unless Net Timers is
completely up.
ACTION: No control operation was performed. If this occurs during
network shutdown, it can probably be ignored. If it occurs at any other
time, submit an SR.
MESSAGE: Bad/unknown function code
3400 CLAS0003 CAUSE: An unrecognized or unsupported function code was passed in a
call to NETTMR_CONTROL. Only supported control functions can be acted
on.
ACTION: The call was ignored; the operation of Net Timers should be
unaffected. However, some other module on the system seems to be
passing bad function codes. If necessary, submit an SR.
MESSAGE: Not up, stop ignored
4020 CLAS0004 CAUSE: An attempt was made to shut Net Timers down before a
successful startup, or during or after a shutdown. Multiple shutdowns
are not allowed.
ACTION: No harm was done, however some other module on the
system, possibly CP, seems to be confused. If necessary, submit an SR.
MESSAGE: Stopping
4040 CLAS0004 CAUSE: Net Timers is being shut down (PARM = Net Timers port data
address).
ACTION: No action is required.
MESSAGE: Unfreed systimers remain
4060 CLAS0002 CAUSE: While releasing in use system timers during shutdown, the
system routine Release_timer reported an error. All in use timers are
normally deallocated during any shutdown of Net Timers (PORT =
unfreed system timer ID, PARM = status from Release_timer).