NS3000/iX Error Messages Reference Manual (36923-90041)

430 Chapter19
Logging Location Codes
L2Resolve Logging Location Codes
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: None
25 Log Class 2 CAUSE: Incoming disconnect before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: None
26 Log Class 2 CAUSE: Unknown event before L2Resolve is fully operational.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
27 Log Class 2 CAUSE: Outbound connect request would exceed maximum number of
connections.
ACTION: A maximum of 64 connections is allowed. Wait until a
connection is closed and try again.
MESSAGE: None
28 Log Class 2 CAUSE: Connect reply received for an unknown connection.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
29 Log Class 2 CAUSE: Disconnect reply message when maximum number of
connections exceeded.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
30 Log Class 2 CAUSE: Disconnect reply received for an unknown connection.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
31 Log Class 2 CAUSE: Disconnect request received for an unknown connection.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
32 Log Class 2 CAUSE: Invalid connect/disconnect message.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
33 Log Class 3 CAUSE: Outbound connection request during network shutdown.