NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 429
Logging Location Codes
L2Resolve Logging Location Codes
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
15 Log Class 3 CAUSE: A connection request has been rejected.
ACTION: Informative message. The network has been shut down, or a
connection request has been refused by the other end.
MESSAGE: None
17 Log Class 2 CAUSE: Invalid request from upper layers in current state.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
18 Log Class 2 CAUSE: Invalid request from lower layers in current state.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
19 Log Class 3 CAUSE: Reject of an incoming connection request because maximum
number of connections active.
ACTION: A maximum of 64 connections is allowed. Retry connection
after one has been closed.
MESSAGE: None
21 Log Class 3 CAUSE: Connect event message before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see “Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: None
22 Log Class 2 CAUSE: Incoming connect reply before L2Resolve is fully operational.
ACTION: Wait for L2Resolve to finish initialization and try the
connection again. If the problem persists, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: None
23 Log Class 2 CAUSE: Incoming disconnect reply; maximum connections exceeded.
ACTION: A maximum of 64 connections is allowed. Wait until one
connection is closed and try again. If the problem persists, see Appendix
A, “Submitting an SR,” of this manual.
MESSAGE: None
24 Log Class 2 CAUSE: Incoming disconnect reply before L2Resolve is fully
operational.