NS3000/iX Error Messages Reference Manual (36923-90041)

426 Chapter19
Logging Location Codes
IPU Logging Location Codes
ACTION: Shut down the transport (NETCONTROL STOP). Check the
configuration file for a disparity between the number of networks
configured and maximum networks specified.
MESSAGE: None
15 CLAS0002 CAUSE: Network number in a Stop Net message not found in the DCN
table (never started).
ACTION: Error probably occurred when starting the network. See error
at log location 12 above.
MESSAGE: None
16 CLAS0006 CAUSE: Log statistics prior to port termination (PARM unused).
ACTION: Informative.
MESSAGE: None
18 CLAS0002 CAUSE: Encountered buffer manager error attempting to return the
buffers on message queues before terminating the port (PARM =
FREEBUF result code).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
19 CLAS0004 CAUSE: Indicates termination of the IPU port.
ACTION: Informative message.
MESSAGE: None
20 CLAS0002 CAUSE:
A routing update indicates that a network is now reachable but there
is not enough room in the distance matrix table to record it (PARM unused).
ACTION: Reconfigure to increase maximum networks on the IP Update
protocol screen.
MESSAGE: None
25 CLAS0002 CAUSE: Could not process a network shutdown routing update because
gateway in the routing update could not be found in the distance matrix
table (PARM unused).
ACTION: Should not happen normally. Probable cause is an inability to
process a network start routing update (because of lack of table space)
that would have put the gateway into the distance matrix.
MESSAGE: None
27 CLAS0002 CAUSE: Could not process a network routing update because there was
not enough room in an internal gateway index table (PARM unused).
ACTION: See Appendix A, “Submitting an SR,” of this manual.