NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 423
Logging Location Codes
IP Logging Location Codes
MESSAGE: None
191 CLAS0002 CAUSE: An error was detected while attempting to start a timer for
inbound reassembly (PARM = get_timer result).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
192 CLAS0002 CAUSE: An inbound buffer could not be freed while processing a partial
datagram (reassembly) (PARM = bmgr_free_buffer result).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
193 CLAS0002 CAUSE: An inbound buffer that was being held for reassembly could
not be freed (PARM = bmgr_free_buffer result).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
194 CLAS0002 CAUSE: An inbound buffer could not be freed while processing a partial
datagram (reassembly) (PARM = bmgr_free_buffer result).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
195 CLAS0002 CAUSE: An entry could not be allocated for managing a delayed reply
from either probe or dial.
ACTION: This may occasionally happen. However, if it is happening
frequently, the number of probe/dial wait queue elements may have to
be increased. The disadvantage of doing this is that additional buffers
are held while path resolution is under way. If the problem persists, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
196 CLAS0003 CAUSE:
Path resolution failure reported from a delayed probe/dial request
(PARM = ns_path_resolve result).
ACTION: May indicate a misconfiguration of network or a failed link.
MESSAGE: None
197 CLAS0002 CAUSE: A failure was detected while attempting to send NI a message
during outbound store and forward processing (PARM = send_msg
result).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
198 CLAS0002 CAUSE: An error was detected while attempting to retrieve buffer pool
information about a store and forward pool (PARM = bmgr_pool_info
result).