NS3000/iX Error Messages Reference Manual (36923-90041)

402 Chapter19
Logging Location Codes
Dial ID Logging Location Codes
MESSAGE: None
86 CLAS0003 CAUSE: Dial is entering the TIME WAIT state after a normal ack-ack
message.
ACTION: None. Informational only.
MESSAGE: None
87 CLAS0003 CAUSE: A link failure occurred, and Dial is cleaning up the resources
(PARM = status).
ACTION: None. Informational only.
MESSAGE: None
88 CLAS0002 CAUSE: A call to BFMGETBUF failed when attempting to get an
outbound buffer for a reply packet (PARM = result of BFMGETBUF).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
89 CLAS0002 CAUSE: A call to BFMGETBUF failed when attempting to get an
outbound buffer for an acknowledgment packet (PARM = result of
BFMGETBUF).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
90 CLAS0002 CAUSE: A call to BFMGETBUF failed when attempting to get an
outbound buffer for an ack-ack packet (PARM = result of BFMGETBUF).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
91 CLAS0002 CAUSE: The Dial ID protocol has waited for approximately five minutes
for transmission of a packet. The connection attempt is aborted.
ACTION: If the link is a manual dial link, then the operator probably
never dialed the phone or replied to the console request. If the link is an
autodial link, then there could be failure with the autocall unit or the
remote node is not answering the phone.
MESSAGE: None
92 CLAS0002 CAUSE: Received an inbound dial request for a route that is already
connected.
ACTION: None.
MESSAGE: None
93 CLAS0002 CAUSE: Timer expired but no matching queue element could be found.
ACTION: None.