NS3000/iX Error Messages Reference Manual (36923-90041)

400 Chapter19
Logging Location Codes
Dial ID Logging Location Codes
ACTION: Verify that the security string configured under the Dial ID
protocol at the local node matches the one sent by the remote node.
MESSAGE: None
48 CLAS0002 CAUSE: The security string contained in the remote node’s request
packet does not match any of the strings configured at the local node.
ACTION: Verify that the security string sent by the remote node
matches one in the list of security strings configured under the Dial ID
protocol at the local node.
MESSAGE: None
49 CLAS0002 CAUSE: A duplicate (retransmitted) request packet has been received,
but the sequence number of the packet does not match the sequence
number of the previous request packet. The packet is discarded (PARM
= sequence number contained in the duplicate packet).
ACTION: Either the packet was corrupted in transit or the remote node
is not transmitting packets correctly. If thought to be the latter case see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
50 CLAS0002 CAUSE: The Dial ID protocol has detected that the configured link size
is too small for the largest packet that may be sent by Dial ID (PARM =
smallest link size acceptable to Dial ID in octal).
ACTION: Reconfigure so that the link is larger than the value contained
in the PARM.
MESSAGE: None
51 CLAS0002 CAUSE: A duplicate (retransmitted) request packet has been received
while two nodes are attempting connection simultaneously, but the
sequence number of the packet does not match the sequence number of
the previous request packet. The packet is discarded (PARM = sequence
number contained in the duplicate packet).
ACTION: Either the packet was corrupted in transit or the remote node
is not transmitting packets correctly. If thought to be the latter case see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
52 CLAS0001 CAUSE: A port message was received on the getbuf reply subqueue
but was not a getbuf reply message (PARM = function code of received
message).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
54 CLAS0002 CAUSE: There is no matching internal Dial ID queue element for the
device in which an ack-ack packet was just received (PARM = index of
device).