NS3000/iX Error Messages Reference Manual (36923-90041)
394 Chapter19
Logging Location Codes
DC/LDM Logging Location Codes
ACTION: DC/LDM continued stopping, but this could indicate a more
serious problem in the High Level I/O system or the DC/LDM. If the
problem occurs every time, see Appendix A, “Submitting an SR,”of this
manual.
CAUSE: While flushing its port subqueues, DC/LDM found an I/O
request message on its port having a nonzero buffer ID, but when
trying to free the BMGR buffer referenced by that message, the system
routine bmgr_free_buffer reported an error.
ACTION: DC/LDM will continue stopping, but if this situation
continues, the network may run out of buffers. In addition, any
subsequent network shutdown may hang. See Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: Error encountered in configurator module
40 CLAS0000 CAUSE: While starting the DC/LDM, an error occurred when adding a
CM Port Dictionary entry, reading the LSS link table, loading a
manager plabel, allocating an HLIO device, creating an LDM port,
adding a device, sending a message, or changing a port subqueue.
ACTION: DC/LDM did not start. See Appendix A, “Submitting an SR,”
of this manual.
CAUSE: While stopping the DC/LDM, an error occurred when deleting a
CM Port Dictionary entry or HLIO device, when releasing a device, or
because of a bad DC/LDM state.
ACTION: DC/LDM continued stopping, but this could indicate a more
serious problem in the High Level I/O system or the DC/LDM. If the
problem occurs every time, see Appendix A, “Submitting an SR,” of this
manual
CAUSE: While flushing its port subqueues, DC/LDM found a read event
message on its port having a nonzero buffer ID, but when trying to free
the BMGR buffer referenced by that message, the system routine
bmgr_free_buffer reported an error.
ACTION: DC/LDM will continue operating, but if this situation
continues, the network may run out of buffers. In addition, any
subsequent network shutdown may hang. See Appendix A, “Submitting
an SR,” of this manual.