NS3000/iX Error Messages Reference Manual (36923-90041)

382 Chapter19
Logging Location Codes
NS Configurator Logging Location Codes
MESSAGE: INTERNAL ERROR; Internal resource error
4 CLAS0002 CAUSE: When NETCP attempted to create a new NI or a new protocol
module for an existing NI, after successfully creating a Port Data Area
and locating a server plabel, an error occurred while trying to create a
message port for the module (PARM = 32-bit status returned by the call
to create_port).
ACTION: There may be a problem with the Ports subsystem of MPE, or
the system may be low on memory. If necessary, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
5 CLAS0002 CAUSE: When NETCP attempted to create a new protocol module for
an existing NI, after successfully creating a Port Data Area, an error
occurred while trying to create a message pool for the modules message
port (PARM = 32-bit status returned by the call to create_pool).
ACTION: There may be a problem with the Ports subsystem of MPE, or
the system may be low on memory. If necessary, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
6 CLAS0002 CAUSE: When NETCP attempted to create a new protocol module for
an existing NI, after successfully creating some data structure, an error
occurred while trying to add that structure's ID into the NS Registry
(PARM = 32-bit status returned by the call to reg_add_entity).
ACTION: The NS registry may be full. Try stopping and restarting
Transport. If the problem persists, see Appendix A, “Submitting an SR,”
of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
7 CLAS0002 CAUSE:
When NETCP attempted to create a new NI or a new protocol module
for an existing NI, after successfully creating a message port for the module,
an error occurred while trying to send the first initialization message to it
(PARM = 32-bit status returned by the call to send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE. See
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
8 CLAS0002 CAUSE: When NETCP attempted to create a new protocol module for
an existing NI, after successfully creating a message port for the
module and sending other messages to it, an error occurred while trying
to send a Protocol Start message (PARM = 32-bit status returned by the
call to send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE or
a bug in the Module Configurator. See Appendix A, “Submitting an SR,”
of this manual.