NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 369
Logging Location Codes
Control Process Logging Location Codes
previous error and this error. Stop the network. If there is no hang, then
try restarting the network. If the problem persists, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
652 CLAS0002 CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,
NETCP encountered an error trying to start the UDP protocol module
(PARM = 32-bit status returned by the call to tcp_module_config).
Always preceded by another error from another entity (having a
different Entity number, such as 151–160), logging the reason for the
original failure.
ACTION: Some of the general protocols were started, but Transport will
not work. Older versions of Transport will improperly continue the
startup after this error, and may also hang when stopped. Record the
previous error and this error. Stop the network. If there is no hang, then
try restarting the network. If this problem persists, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
653 CLAS0002 CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,
NETCP encountered an error trying to start the PXP protocol module
(PARM = 32-bit status returned by the call to tcp_module_config).
Always preceded by another error from a different entity (having a
different Entity number, such as 151–160), the configurator, logging the
reason for the original failure.
ACTION: This error in itself was not fatal, and general protocol startup
continued. However, dynamic name resolution will fail. To clear the
problem, stop then restart the network. If this problem persists, record
the previous error and this error, then see Appendix A, “Submitting an
SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
654 CLAS0002 CAUSE: While attempting to start all the general protocols because a
:NETCONTROL command was starting a new instance of Transport,
NETCP encountered an error trying to start the IPU (IP Update)
module (PARM = 32-bit status returned by the call to
tcp_module_config). Always preceded by another error from another
entity (having a different Entity number, such as 151–160), logging the
reason for the original failure.
ACTION: The general protocols were started, but Transport will not
work. Older versions of Transport will improperly continue the startup
after this error, however path resolution will fail, and Transport may
also hang when stopped. Record the previous error and this error. Stop
the network. If there is no hang, then try restarting the network. If the
error still occurs, a common cause is that NMMGR “Unguided Confide”