NS3000/iX Error Messages Reference Manual (36923-90041)

366 Chapter19
Logging Location Codes
Control Process Logging Location Codes
MESSAGE: INTERNAL ERROR; Module Deconfig Failed
641 CLAS0002 CAUSE: While shutting down Transport due to a system shutdown or a
:NETCONTROL STOP command, NETCP detected an error or warning
while attempting to stop the Net Timers module (PARM = 32-bit status
returned by the call to nettmr_module_deconfig). Always preceded
by other errors from Net Timers, indicating the cause of the original
failure.
ACTION: This error in itself was not fatal, and shutdown continued.
However, some system resources may be lost until after the next system
restart. One possible cause would be if a tool has already been used to
stop Net Timers, in which case NETCP cannot stop it; in this case
ignore the error. Inspect the previous error, and if necessary, or if this
problem occurs repeatedly, see Appendix A, “Submitting an SR,”of this
manual.
MESSAGE: INTERNAL ERROR; Module Deconfig Failed
642 CLAS0002 CAUSE: While stopping an NI due to a system shutdown or a
:NETCONTROL STOP command, NETCP detected an error trying to
delete the NI (PARM = 32-bit escape code returned by the call to
ni_module_deconfig). Always preceded by another error from
another entity (having a different Entity number, such as 151–160),
indicating the cause of the original failure.
ACTION: This error in itself was not fatal, and shutdown continued.
However, some system resources may be lost until after the next system
restart. Inspect the previous error and if necessary, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
643 CLAS0002 CAUSE: While stopping an NI because a network was being shut down,
NETCP tried to free a NIB (Network Interface Block) it had previously
allocated for the NI, but was unable to locate that NIB in other NETCP
tables (PARM = 32-bit address of the missing NIB).
ACTION: This error in itself was not fatal, and shutdown continued.
However, NETCP may be confused. If the problem occurs repeatedly,
see Appendix A, “Submitting an SR,”A of this manual.
MESSAGE: INTERNAL ERROR; Configuration file error
644 CLAS0002 CAUSE: While initializing an NI for a network that was being started,
NETCP was unable to read the global information record from the
NETXPORT.NI.name path in the NMCONFIG file (PARM = 32-bit
status returned by the call to nmconfgetdata).
ACTION: The NI did not start. Stop the network, run NMMGR, and
check the NI configuration for the NI which did not start. Validate the
file. Then restart the network. If the problem persists, the NMCONFIG