NS3000/iX Error Messages Reference Manual (36923-90041)

354 Chapter19
Logging Location Codes
Control Process Logging Location Codes
MESSAGE: Bad status
602 CLAS0002 CAUSE: While attempting to send an X25 restart request message to
the X25 protocol module, NETCP encountered an error on the send
(PARM = 32-bit status returned by the call to send_msg).
ACTION: X25 did not receive the restart request. This will cause the
X25 network to enter a bad state. Stop and restart that network. If this
problem continues, see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: Bad status
603 CLAS0002 CAUSE: On an SNA network NI, while attempting to send a bind
message to the L2RESOLVE module of SNA, NETCP encountered an
error on the send (PARM = 32-bit status returned by the call to
send_msg).
ACTION: This will prevent SNA from establishing any connections.
Stop and restart the network. If this problem continues, see Appendix
A, “Submitting an SR,” of this manual.
MESSAGE: Bad status
604 CLAS0002 CAUSE: On an SNA network NI, while attempting to send a device
disconnect message to the L2RESOLVE module of SNA for a device
which had previously established a level 1 connection, NETCP
encountered an error on the send (PARM = 32-bit status returned by
the call to send_msg).
ACTION: The device was not disconnected. Restart the network. If this
problem continues, then see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: BUFFER MANAGER; Buffer manager error
605 CLAS0003 CAUSE: In the last phases of stopping the last device on an NI that was
being shut down, NETCP encountered an error while trying to delete
that NI inbound buffer pool (PARM = 32-bit status returned by the call
to bmgr_delete_pool).
ACTION: This error was not fatal, and network shutdown continued.
However, the amount of system memory used by the pool may be
inaccessible until the next system restart. Probably some buffers for the
pool were lost, or are still outstanding in protocol modules which had
previously encountered errors. If the problem occurs repeatedly, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
606 CLAS0002 CAUSE: In the last phases of stopping the last device on an NI that was
being shut down, NETCP found the NI inbound buffer pool ID in its
device table, but not in its read pool table (PARM = 16-bit buffer size for
the missing pool ID; this number was used internally in the NS
Registry to name that pool).