NS3000/iX Error Messages Reference Manual (36923-90041)

352 Chapter19
Logging Location Codes
Control Process Logging Location Codes
ACTION: The LAN network did not start. Use the LANDAD tool to
verify the LAN hardware is functioning correctly. If it looks good, there
may be a problem with the LAN driver software or a bug in NETCP; see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Device close
420 CLAS0002 CAUSE: While stopping an 802.3 LAN device prior to closing its driver,
NETCP encountered an error attempting to delete multicast addresses
it supposedly added previously to the driver’s KSO (PARM = 32-bit
status returned by the call to ieee_multicast_delete).
ACTION: This error in itself was not fatal, and device shutdown
continued. After shutdown, use the LANDAD tool to verify the LAN
hardware is functioning correctly. If it looks good but the problem
persists, then see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
423 CLAS0002 CAUSE: While stopping an X25 network, NETCP encountered an error
attempting to delete the X25 Flow Control Manager (PARM = 32-bit
status returned by the call to netfc_kill). The Flow Control Manager
dynamically allocates the flow control buffer pools for X25.
ACTION: This error in itself was not fatal, and shutdown of the X25 NI
continued. If the error occurs every time, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
428 CLAS0002 CAUSE: NETCP was about to send a level 3 restart message to the X25
protocol, but the NETCP tables showed a restart had already been sent
(PARM = 0).
ACTION: No restart message was sent this time, but this situation
should not have occurred. If it occurs repeatedly, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
429 CLAS0002 CAUSE: NETCP was about to send a level 3 stop message to the X25
protocol, but the NETCP tables showed a restart had already been sent
(PARM = 0).
ACTION: No stop message was sent this time, but this situation should
not have occurred. If it occurs repeatedly, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: Level 3 Down on DTC
431 CLAS0003 CAUSE: NETCP received an SDI async event message informing it that
the X25 RLM was not ready, meaning that levels 3 and 2 have gone
down on the DTC for an X25 link already started by Transport (PARM
= 32-bit SDI status field from the message).