NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 347
Logging Location Codes
Control Process Logging Location Codes
indicating its LAPB PSI link reported that the remote side was
establishing or had already established a connection (PARM = 16-bit
connect event code from LAPB).
ACTION: None. This is an informative error message only. The
connection was successfully established, but through the initiative of
the remote side, not the local. NETCP then disconnected the device at
the local side.
MESSAGE: INTERNAL ERROR; Dial
312 CLAS0003 CAUSE: While restarting a link requiring autodial, because an
unexpected error occurred while connected (see error 257), NETCP
instructed the local side to establish a level 2 connection. A connection
was established, but then failed because NETCP received an
asynchronous DCLDM event message indicating its LAPB PSI link
reported another failure (PARM = upper 16 bits of status from the call
to xp_connect_the_driver: usually the connect event code from
LAPB).
ACTION: NETCP disconnected the device and notified protocols that
the link went down. This is most likely a link level problem. Consult the
link diagnostics and check the modems. Confirm that the link
connection is working for the affected link. If the link is connection is
working, then seeAppendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Dial
313 CLAS0003 CAUSE: While restarting a LAPB PSI link because an unexpected error
occurred while connected (see error 257), NETCP encountered an error
when it instructed the local side to reestablish a level 1 connection so
that a level 2 connection can be established later (PARM = 32-bit status
returned by the call to xp_connect_the_driver).
ACTION: NETCP brought the device and its driver down, and notified
protocols that the link went down. This is most likely a link level
problem. Another possibility is that the DCLDM or LAPB driver are
hung. Consult the link diagnostics and check the modems. Confirm that
the link connection is working for the affected link. If the link is
connection is working, then see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: INTERNAL ERROR; Dial
315 CLAS0003 CAUSE: While processing a legal dial request message, NETCP found
that the link appeared to already be connected, so dialing was not
possible (PARM = adjusted LAPB status).
ACTION: None. This is an informative error message only. Another
class-3 logging message may have preceded this, indicating that the
link just connected.