NS3000/iX Error Messages Reference Manual (36923-90041)

346 Chapter19
Logging Location Codes
Control Process Logging Location Codes
ACTION: Turn on the autodial unit and check for power and correct
cabling. Then attempt to dial out again.
MESSAGE: OUTBOUND; Data line occupied
303 CLAS0003 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI autodial failed because the line
was busy or a phone line was not available (PARM = 16-bit internal
ldev number of the device). (Some pre-5.0 versions of Transport also
incorrectly reported wrong autodialer cables under this location; now
see error 674).
ACTION: Attempt to dial out again later when a phone line is free.
MESSAGE: Device restarting
304 CLAS0003 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI link experienced a power failure,
resulting in a disconnect of the phone line (PARM = 16-bit internal ldev
number of the device). May be followed by informative error 101 if
outbound data was queued when the error occurred.
ACTION: None. This is an informative error message only. NETCP will
now automatically attempt to bring the device driver down and then
back up.
MESSAGE: INTERNAL ERROR; Internal resource error
305 CLAS0002 CAUSE: During later stages of NETCP’s initial startup, NETCP was
unable to create a message pool for its own process port (PARM = 32-bit
status returned by the call to create_pool).
ACTION: The transport was not started. There is a problem with the
operating system or a bug in NETCP; see Appendix A, “Submitting an
SR,”A of this manual.
MESSAGE: INTERNAL ERROR; NM Entry
306 CLAS0003 CAUSE: During later stages of NETCP’s initial startup, NETCP was
unable to add its own port message pool ID to the NS Registry (PARM =
32-bit status returned by the call to reg_add_entity).
ACTION: This error was not fatal, and startup continued; use of the
Registry here is not critical. However, creation of the NS Registry by
NETCP may have failed (see error 285), or the Registry may be full. If
the message occurs every time, see Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: INTERNAL ERROR; Dial
311 CLAS0003 CAUSE: While restarting a link requiring autodial, because an
unexpected error occurred while connected (see error 257), NETCP
instructed the local side to establish a level 2 connection. This failed
because NETCP received an asynchronous DCLDM event message