NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 345
Logging Location Codes
Control Process Logging Location Codes
MESSAGE: BUFFER MANAGER; Buffer manager error
292 CLAS0002 CAUSE: While building a buffer containing all X25 configuration data
for a network, NETCP successfully obtained a buffer of the supposedly
correct size, but later encountered an error attempting to write a block
of Network Directory address information to the buffer (PARM = 32-bit
status returned by the call to bmgr_write_buffer).
ACTION: Check the configuration file using NMMGR, to see that the
amount of X25 configuration data seems to be within limits. Also verify
your system has any and all software patches that may be needed to
use the amount of X25 configuration data you are specifying. If the
problem still cannot be isolated, see Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: INTERNAL ERROR; Auto dial failure
293 CLAS0002 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI’s autodial operation failed due to
an internal autodialer problem (PARM = 16-bit internal ldev number of
the device).
ACTION: Check the autodialer cabling and strapping or configuration,
and diagnose the autodialer hardware. Then retry the operation.
MESSAGE: PACKET DISCARD; Illegal phone number
294 CLAS0003 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI card was passed a bad autodial
telephone number (PARM = 16-bit internal ldev number of the device).
ACTION: Use NMMGR to check the syntax of the telephone number in
the NMCONFIG file for the affected link. Then retry the dialing
operation. If the problem persists, see Appendix A, “Submitting an SR,”
of this manual.
MESSAGE: PACKET DISCARD; Auto dial not completed
295 CLAS0003 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that a LAPB PSI’s autodial operation was not
completed, possibly because the site being dialed is either busy or not
picking up (PARM = 16-bit internal ldev number of the device).
ACTION: Attempt to dial out again at a later time, or reconfigure the
remote site and the local NMCONFIG mappings to provide additional
phone connections into that site.
MESSAGE: INTERNAL ERROR; No auto dialer power
296 CLAS0003 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI autodial operation was
attempted while the autodialer hardware was not powered up (PARM =
16-bit internal ldev number of the device).