NS3000/iX Error Messages Reference Manual (36923-90041)

342 Chapter19
Logging Location Codes
Control Process Logging Location Codes
MESSAGE: INTERNAL ERROR; Configuration file error
278 CLAS0002 CAUSE: While processing a :NETCONTROL command to start or update
a network or add a link, NETCP successfully opened the NMCONFIG
file, but was unable to lock it (PARM = 32-bit status returned by the call
to nmconflockfile).
ACTION: The command did not execute, and NETCP closed the open
file. Check that the NMCONFIG file exists and is not already opened by
some other user, such as someone running NMMGR. If this is not the
problem and the message persists, see Appendix A, “Submitting an SR,”
of this manual.
MESSAGE: INTERNAL ERROR; Configuration file error
280 CLAS0002 CAUSE: While processing a :NETCONTROL command to start or update
a network or add a link, NETCP was unable to open the NMCONFIG
file (PARM = 32-bit status returned by the call to nmconfopen).
ACTION: The command did not execute. Check that the NMCONFIG
file exists and is not already opened by some other user, such as
someone running NMMGR. If this is not the problem and the message
persists, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Internal resource error
281 CLAS0002 CAUSE: NETCP received a dial request message but the entity whose
reply port was in the message was not one of the network specific
protocols known to NETCP for this NI (PARM = 0).
ACTION: Some entity other than DIAL may be attempting dial
requests. See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: Device Startup Warning
282 CLAS0003 CAUSE: An attempt to physically start a device was successful, but
returned a positive status meaning some sort of unexpected warning
occurred (PARM = 32-bit status returned by the call to nslopenlink).
ACTION: None. This is an informative error message, and exists for
pre-5.0 systems only. If you want more information, try enabling
additional logging for the link subsystem corresponding to the type of
NI for the network reporting the warning, then reproduce the message.
If this still does not reveal the cause, see Appendix A, “Submitting an
SR,” of this manual.
MESSAGE: Device Shutdown Warning
283 CLAS0003 CAUSE: An attempt to physically stop a device failed with a positive
nonzero status meaning an unexpected warning (not an error) occurred
(PARM = 32-bit status returned by the call to nslcloselink). Physical
stop includes all shutdown and deletion of a link driver and its
dependent modules and any connections to the NMS subsystem or the
operating system, reset of link hardware, plus optional deletion of a
DCLDM, so any error along the way will be detected here by NETCP.