NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 18 305
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
MESSAGE: PSI cannot send a frame across the line.
2505 CAUSE: Possible causes for this problem are as follows:
1. Link could be down.
2. Bad PSI hardware.
3. Internal PSI or driver error.
ACTION: Possible actions for this problem are as follows:
1. Check the cabling and modem.
2. Run Sherlock diagnostics to determine the cause.
3. Write down the console error messages, submit an SR and call your
Hewlett-Packard representative.
MESSAGE: Bad message parameter passed to the driver.
2506 CAUSE: The driver received a bad meta language tag while binding
with NS.
ACTION: Write down the console error message, submit an SR and call
your Hewlett-Packard representative.
MESSAGE: Bad message received from NS.
2507 CAUSE: The driver received a bind message while it was already bound.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: The PSI card is not ready for operation.
2508 CAUSE: The driver was requested to perform a command when the PSI
card was not ready.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: Bad completion from the PSI.
2509 CAUSE: The module dependent field returned by the PSI does not make
any sense.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: Bad message received from NS.
2510 CAUSE: The driver was asked to execute a command without being
bound to upper layer.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.