NS3000/iX Error Messages Reference Manual (36923-90041)

304 Chapter18
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
ACTION: Check to see if the cable is properly attached. If it is, try
another cable. If you still get this error, write down the error
information displayed on the console, submit an SR, and call you local
Hewlett-Packard representative.
MESSAGE: There was a read from the PSI which completed with a
error.
2500 CAUSE: Possible causes for this problem are as follows:
1. The link is down.
2. You have a faulty PSI.
3. Internal driver, firmware or system error.
ACTION: Possible actions for this problem are as follows:
1. Check the cabling and modem on the PSI.
2. Run Sherlock Diagnostics on the PSI.
3. Write down the console error message, file an SR and call your
Hewlett-Packard representative.
MESSAGE: The driver does not have any more storage for commands
to the PSI.
2501 CAUSE: Unexpected use of driver subqueues may create this problem.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: The PSI has completed a bad command.
2502 CAUSE: Bad Asynchronous event quad completed by the PSI.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: The driver is unable to continue operation.
2503 CAUSE: The driver received a command or is in a state where it cannot
continue operation.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.
MESSAGE: An unexpected command was received by the driver.
2504 CAUSE: A completion by the PSI was received in an invalid state.
ACTION: Write down the error information displayed on the console,
submit an SR and contact your Hewlett-Packard representative.