NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 18 299
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Attempted impossible state after a request or completion.
1047 CAUSE: The driver attempted to enter a state which it should never be
able to get into, and ceased operations instead. Memory data
corruption, a driver bug, or a problem with the execution priorities of
the driver and/or its hardware may exist.
ACTION: This problem should produce a dump. Keep the raw dump
along with the error information displayed on the console, call your
Hewlett-Packard representative, and submit an SR.
MESSAGE: Driver notified of powerfail by system.
1048 CAUSE: The driver was notified that power returned after a power
failure of any duration.
ACTION: The driver is not capable of recovering from power failures,
and modem connections were probably lost. Restart the link.
MESSAGE: Request received when driver broken.
1049 CAUSE: The driver had to reject a request message because it had
previously become broken for another reason. The rejected request
could not be processed while the driver was broken.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Request received when driver dead.
1050 CAUSE: The driver received a request message during a short time
interval after shutdown completed, but before the driver’s port had
been destroyed by the system. The driver should not be receiving new
requests after shutdown, and it cannot successfully complete them.
ACTION: If this problem occurs repeatedly, call your Hewlett-Packard
representative.
MESSAGE: Request received when hardware in bad state.
1051 CAUSE: Hardware was not ready to process a request message which
required hardware participation.
ACTION: Retry the request at a later time. If the problem persists, call
your Hewlett-Packard representative.
MESSAGE: Not enough TARs available to process request.
1052 CAUSE: The driver could not obtain enough context storage to begin
processing a request, so the request was rejected. Unexpected use of
incorrect port subqueues may have created excessive pending hardware
activity.