NS3000/iX Error Messages Reference Manual (36923-90041)

298 Chapter18
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
ACTION: If you suspect your system may be low on timer resources due
to heavy loading, try restarting the link later. If repeated attempts fail,
warmstart your system. If the problem persists, a system dump will be
required; call your Hewlett-Packard representative.
MESSAGE: Unable to reset an I/O Services timer.
1041 CAUSE: The system rejected an attempt by the driver to reset a timer
supposedly owned by the driver. Memory data corruption may have
occurred.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Unable to release an I/O Services timer.
1042 CAUSE: The driver tried to free a timer which was not recognized by the
system as a valid timer. Memory data corruption may have occurred.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Unable to obtain an I/O Services message frame.
1043 CAUSE: The driver could not obtain a reply-message frame from the
source port of a newly arrived request message, or from a transport port
in the case of a driver-detected asynchronous event. If the system is
otherwise operating well, modules attempting to communicate with the
driver may not be operating with the required capabilities.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Unable to send an I/O Services message to another
process.
1044 CAUSE: A call to the system message-send routine returned in error.
The destination port may belong to a process which no longer exists or
is not operating with the required capabilities.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Unable to release an I/O Services message frame.
1045 CAUSE: A call to the system message-freeing routine returned in error.
The port may belong to a process which no longer exists or is not
operating with the required capabilities, or the message frame was not
recognized by the system as a valid message frame.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Attempting to find I/O Services message on port failed.
1046 CAUSE: The system rejected an attempt by the driver to locate message
frames on its own port. Memory data corruption may have occurred.