NS3000/iX Error Messages Reference Manual (36923-90041)

292 Chapter18
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
MESSAGE: PSI fatal error, dinmode.
1004 CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. Bad PSI hardware.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Run the Sherlock diagnostics on the PSI and call your
Hewlett-Packard representative if a failure is detected.
MESSAGE: PSI fatal bus error.
1005 CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update
tape, and run the Sherlock diagnostics on the PSI. Call your
Hewlett-Packard representative if a failure is detected.
MESSAGE: PSI fatal internal error.
1006 CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update
tape, and run the Sherlock diagnostics on the PSI. Call your
Hewlett-Packard representative if a failure is detected.
MESSAGE: Unknown PSI fatal error.
1007 CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update tape
and run the Sherlock diagnostics on the PSI and call your
Hewlett-Packard representative if a failure is detected.
MESSAGE: The PSI received less data from your Hewlett-Packard
system than it expected.
1008 CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: The PSI received more data from your Hewlett-Packard
system than its internal buffers could handle.
1009 CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.