NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 16 279
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: This probably indicates a driver bug. If the problem happens
frequently, use NMMGR to modify the LINK configuration for this link,
to enable link tracing at startup. Reproduce the problem, then shut
down the link and save the resulting NMTCnnnn.PUB.SYS trace data
file for analysis by Hewlett-Packard. See Appendix A, “Submitting an
SR.”
MESSAGE: (None)
9800 (None) CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read the
network status register, but detected a powerfail instead. A power
failure state was then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: If a power failure has actually occurred, this error can be
ignored; the driver should recover automatically. If the problem
happens every time, see Appendix A, “Submitting an SR.”
MESSAGE: (None)
9830 (None) CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read the
PHY status register on the PHY chip, but detected an error. A hardware
failure state was then signaled. Probably a powerfail occurred.
If a power failure has actually occurred, this error can be ignored; the
driver should recover automatically. Otherwise, the MII bus may have
failed; replace the adapter card. If the same problem persists, see
Appendix A, “Submitting an SR.”
MESSAGE: (None)
9860 (None) CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read a
statistics register, but detected a powerfail instead. A power failure
state was then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.