NS3000/iX Error Messages Reference Manual (36923-90041)

278 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
MESSAGE: (None)
9680 (None) CAUSE: 100VG-AnyLAN link training failed because the LAN
Controller chip unexpectedly reported an interrupt of a type which the
driver should have specifically disabled at startup. A hardware failure
state was then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: Replace the adapter card. If the problem continues, there may
be a driver startup bug; see Appendix A, “Submitting an SR.
MESSAGE: (None)
9710 (None) CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a training frame was sent, the driver tried to
check if the frame was completely transferred out of adapter card
memory, but detected a powerfail instead. A power failure state was
then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: If a power failure has actually occurred, this error can be
ignored; the driver should recover automatically. If the problem
happens every time, see Appendix A, “Submitting an SR.
MESSAGE: (None)
9740 (None) CAUSE: 100VG-AnyLAN link training failed because after the LAN
Controller chip reported a training frame was sent, it had still not
finished transferring frame data out of adapter card memory even after
the driver waited 64 microseconds. A hardware failure state was then
signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: Replace the adapter card. If the problem continues, see
Appendix A, “Submitting an SR.
MESSAGE: (None)
9770 (None) CAUSE: 100VG-AnyLAN link training failed because after the LAN
Controller chip reported a training frame was sent, the driver’s ISR
module detected an unexpected connect state. A software failure state
was then signaled.