NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 1 27
CIERR Error Messages
Network Services Environment Error Messages
ACTION: Terminate the service or services, and reissue the command.
The DSLINE SHOW command will display which services are active for
an environment.
MESSAGE: CANNOT OPEN TRACE FILE filename.
627 CAUSE: A DSLINE TRACE=ON was issued, but the indicated trace file
cannot be opened.
ACTION: Check the parameters for the TRACE option, correct if in
error, and reissue the command.
MESSAGE: CANNOT CLOSE TRACE FILE filename.
628 CAUSE: A DSLINE TRACE=OFF was issued, but the indicated trace file
cannot be closed.
ACTION: Check the parameters for the TRACE option, correct if in
error, and reissue the command.
MESSAGE: CANNOT OBTAIN DATA SEGMENT FOR ENVIRONMENT
TABLE.
629 CAUSE: An extra data segment was not available for the session
environment table, because of a lack of memory or DST entries. No
environments can be defined.
ACTION: Wait and reissue the command later, when memory or DST
entries may become available. If this error occurs frequently, there may
be insufficient DST entries or memory. The system manager may have
to increase the DSTs or memory.
MESSAGE: CANNOT CHANGE NODE NAME FROM nodename WHILE
ACTIVE SERVICES.
630 CAUSE: A DSLINE envid = nodename was executed for an
environment for which one or more services have been established on a
remote node other than nodename. The environment of this node
cannot be changed until the services are finished.
ACTION: Wait for the services to terminate, or terminate the services.
The DSLINE SHOW command can be used to determine the active
services for the environment.
MESSAGE: INVALID ENVIRONMENT ID OR NODE NAME LENGTH.
631 CAUSE: A fully qualified environment or node name in a command was
longer than the allowed maximum of 50 characters.
ACTION: Shorten the name and reissue the command.
MESSAGE: ID OR NODE IN name DOES NOT BEGIN WITH AN ALPHA.
632 CAUSE: The first part of a (fully qualified) environment ID or node
name does not begin with an alphabetic character.
ACTION: Correct the name and reissue the command.