NS3000/iX Error Messages Reference Manual (36923-90041)

264 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
Either there is a bug in the driver or upper layer protocol software, or
there is a system software mismatch. You may require additional
software patches; contact your Hewlett-Packard Representative for
assistance.
MESSAGE: One or more bad bind parms passed by upper level
protocol.
8300 CLAS0001 CAUSE: The driver received a bind (rendezvous) from an upper layer
protocol module, but the specified open ID was out of range of legal open
ID values for this driver (“Cause”= 32-bit value giving the bad ID which
was specified).
ACTION: This problem most likely occurred while starting a new
network subsystem. Attempt to determine which subsystem was being
started when the error occurred and, if possible, which upper layer
protocol was binding. The bind failed. The driver logged the error, then
attempted to send an error reply message back to the protocol module
and continue.
Either there is a bug in the driver or upper layer protocol software, or
there is a system software mismatch. You may require additional
software patches; contact your Hewlett-Packard Representative for
assistance.
MESSAGE: One or more bad bind parms passed by upper level
protocol.
8330 CLAS0001 CAUSE: The driver received a bind (rendezvous) from an upper layer
protocol module, but the pointer to that protocol’s inbound buffer pool
was not specified (“Cause” is not used here).
ACTION: This problem most likely occurred while starting a new
network subsystem. Attempt to determine which subsystem was being
started when the error occurred and, if possible, which upper layer
protocol was binding. The bind failed. The driver logged the error, then
attempted to send an error reply message back to the protocol module
and continue.
Either there is a bug in the driver or upper layer protocol software, or
there is a system software mismatch. You may require additional
software patches; contact your Hewlett-Packard Representative for
assistance.
MESSAGE: One or more bad bind parms passed by upper level
protocol.
8360 CLAS0001 CAUSE: The driver received a bind (rendezvous) from an upper layer
protocol module, but the specified SDI address family was not one of the
values supported by the driver (“Cause”= 32-bit value giving the bad
address family which was specified).