NS3000/iX Error Messages Reference Manual (36923-90041)

230 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
MESSAGE: Bad message for current state.
4030 CLAS0001 CAUSE: The driver received a release-memory reply message it was not
expecting (“Cause”= 16-bit encoded value, giving driver input event
code and current state: HP use only).
ACTION: The driver may already have changed state because of a
shutdown or another problem, in which case this message can be
ignored. Otherwise, the I/O system may be confused. The driver will
drop this message without further action. If the problem occurs
repeatedly, see Appendix A, “Submitting an SR.”
MESSAGE: A driver request failed.
4060 CLAS0001 CAUSE: While attempting to forward a protocol rendezvous (bind)
message to its ISR, the driver encountered an error (“Cause”= 32-bit
status returned by the call to vg_dvr_copy_send_to_isr). Probably
no comm frame was available.
ACTION: This informational error should be preceded by another error
giving a more specific reason for the failure; check log data and look up
that error also, for more actions to take. Most likely the previous error
was fatal and the driver is about to “die”, then will either attempt an
auto-reset or else require a manual shutdown and restart. The driver
dropped this request message without further action, likely resulting in
timeouts and failure of the network and/or protocol to successfully start
up.
MESSAGE: Driver encountered a software problem.
4090 CLAS0001 CAUSE: Before attempting to forward a protocol rendezvous (bind)
request to its ISR, the driver discovered the ISR was already in a “dead”
state and unable to process requests (“Cause”= 32-bit status stating the
driver is “dying”).
ACTION: If the operator already knows the driver is in the process of
being closed, this error can be ignored. The driver attempted to send an
error reply for the rendezvous request. The ISR may also be “dead” as a
result of a serious previous error. A diagnostic reset action may clear
this condition.
MESSAGE: Bad message for current state.
4120 CLAS0001 CAUSE: The driver received a request to reset itself too early in the
driver’s life cycle before it had ever brought up the adapter card, or at a
point late in shutdown when recovery is no longer needed (“Cause”=
16-bit encoded value, giving driver input event code and current state:
HP use only).
ACTION: This error is informational only. If the reset request was
manually sent by a user, such as via the VGPBA diagnostic tool, an
error reply will be returned; resets are not allowed (or needed) when