NS3000/iX Error Messages Reference Manual (36923-90041)

218 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
If the problem happens every time, enable link tracing via
:LINKCONTROL then reproduce the link shutdown problem (the trace
file will close automatically). Save the resulting trace file
(NMTC####.PUB.SYS) on tape for Hewlett-Packard analysis, and see
Appendix A, “Submitting an SR.
MESSAGE: Driver is shutting down.
2800 CLAS0003 CAUSE: The driver is being shut down. The last subsystem that was
using the driver is now closing it.
ACTION: This event is informational only. No action is needed.
MESSAGE: No adapter card found on specified HP-PB bus.
2830 CLAS0001 CAUSE: During initial driver startup, an HP-PB bus was not found at
the hardware path specified in NMCONFIG.
ACTION: The driver did not start up. Use NMMGR to verify the path
in NMCONFIG is correct and complete, and matches the path where a
supported 100VG-AnyLAN or 100Base-T adapter card is installed in
your computer backplane. If the path resides on a bus converter, use
SYSGEN to make sure a path to that bus converter exists in the I/O
configuration. A diagram of the backplane slot paths, often found in the
rear of your system near the backplane, may help you. You can also try
an offline diagnostic utility such as MAPPER, or an online utility such
as SYSMAP, to precisely determine your hardware configuration. If
necessary, change the SYSGEN or NMCONFIG configurations or
contact your Hewlett-Packard Representative for assistance in
determining paths or correcting bus hardware problems.
MESSAGE: Bad hardware ID or path.
2860 CLAS0001 CAUSE: During initial driver startup, a supported 100VG-AnyLAN or
100Base-T adapter card was not found at the hardware path specified
in NMCONFIG.
ACTION: The driver did not start up. Verify the path in NMCONFIG is
correct and complete, and matches the path where a supported
100VG-AnyLAN or 100Base-T adapter card is installed in the computer
backplane. Verify the Power LED is lit on that adapter. If necessary,
contact your Hewlett-Packard Representative for hardware assistance.
MESSAGE: Cannot install interrupt handler.
2890 CLAS0001 CAUSE: During initial driver startup, the driver was unable to add its
ISR into the MPE I/O system, as an interrupt handler routine for any
adapter card interrupts on that EIR bit (“Cause”= 32-bit status
returned by the call to io_config_int).