NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 1 21
CIERR Error Messages
MESSAGE: ABORT DOES NOT ACCEPT ANY PARAMETERS.
5073 CAUSE: Parameters were specified for an :NSCONTROL ABORT option.
ACTION: Delete the parameters and reissue the command.
MESSAGE: EXPECTED ONE OF USERS, SERVICES, SERVERS, OR
ALL.
5074 CAUSE: The parameter for a SHOW option in an NSCONTROL command
was not one of the defined choices.
ACTION: Correct the SHOW command and reissue the parameters.
MESSAGE: EXPECTED MAXIMUM NUMBER OF SERVERS (=> 0 and
>32767).
5075 CAUSE: The third parameter of a SERVER option in an NSCONTROL
command was not a maximum number of servers, a positive integer.
ACTION: Correct the SERVER option and reissue the command.
MESSAGE: WILD CARD CHARACTERS NOT ALLOWED IN NODE
NAME.
5076 CAUSE:A wild card character (@, #, or ?) was used in a node name. Node
names cannot be generic.
ACTION: Correct the node name and reissue the command.
MESSAGE: NETWORK SERVICE SOFTWARE VERSIONS DO NOT
MATCH.
5077 CAUSE: The version or update, or fix levels of the Network Service
software modules are not compatible. NS cannot be initiated if its
software is incompatible.
ACTION: List the versions for the NS software modules, using
NSCONTROL VERSION=MOD or RUN NMAINT.PUB.SYS. Identify the
incompatible software modules, and replace with the assistance of your
SE.
MESSAGE: PM CAPABILITY NEEDED TO USE DEBUG OPTION.
5078 CAUSE: An NSCONTROL DEBUG or NSCONTROL SERVER=,,,DEBUG
command was executed, but the user does not have PRIVILEGED
MODE (PM) capability. These commands cause a privileged breakpoint
to be activated.
ACTION: Execute the command from a user with PM capability.
MESSAGE: SYSTEM CONSOLE NEEDED TO USE DEBUG OPTION.
5079 CAUSE: An NSCONTROL DEBUG or NSCONTROL SERVER=,,,DEBUG
command was executed from a terminal other than the system console.
These commands cause a breakpoint to appear at the system console.
ACTION: Execute the command from the system console.