NS3000/iX Error Messages Reference Manual (36923-90041)

208 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
contains the multicast for 100VG-AnyLAN and 100Base-T) or obtain
newer patches; contact your Hewlett-Packard Representative for
assistance. If reinstalling software does not solve the problem, see
Appendix A, “Submitting an SR.”
MESSAGE: The link is already started.
1650 CLAS0001 CAUSE: During the first link-open operation by an upper level
subsystem, the link module configurator attempted to create a new
instance of the link driver, but discovered the driver was already
created and has been opened at least once (“Cause”= 32-bit status from
the call to io_configure, saying the link is already started).
ACTION: This is an informational warning only. The module
configurator will leave the link driver up and stop trying to start it
again. Usually preceded by another error.
MESSAGE: Cannot add to link table.
1660 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator successfully started the driver, but
encountered an error trying to add the link to the link table (“Cause”=
32-bit status from the call to lsslktbladd).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Possibly too many links are started.
If not. try starting a different link, to see if that works. If not, first try
doing a :LINKCONTROL @ command to see if any LSS errors occur. If
they do, you may need to reinstall MPE software; contact your
Hewlett-Packard Representative for assistance. Otherwise try
restarting the system to see if it corrects the problem or
LINKCONTROL errors. If none of these suggestions helps, see
Appendix A, “Submitting an SR.”
MESSAGE: Cannot freeze a memory area.
1700 CLAS0001 CAUSE: During a link-close operation by an upper level subsystem, the
link module deconfigurator was preparing to send new configuration
data to the driver, but encountered an error while trying to freeze that
data into memory (“Cause”= 32-bit status from the call to freeze).
ACTION: The system may be low on available memory. Try closing any
unnecessary applications or sessions and retry the operation. The
driver did not receive the updated configuration data. The module
deconfigurator attempted to continue with the close. If this happens
every time, see Appendix A, “Submitting an SR.”