NS3000/iX Error Messages Reference Manual (36923-90041)

202 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
ACTION: If this error occurs, there may be additional driver-specific
errors logged, giving more information about the problem. Attempt to
locate those errors and look them up also. The open did not succeed.
The module configurator cleaned up and returned an error to the
subsystem.
MESSAGE: No adapter card found on specified HP-PB bus.
1110 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find an HP-PB bus at the hardware
path specified in NMCONFIG (“Cause” is not used here).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported 100VG-AnyLAN or 100Base-T adapter card
is installed in your computer backplane. If the path passes through bus
converters, verify the SYSGEN configuration has entries for the
higher-level bus converters leading to that path. A diagram of the
backplane slot paths, often found in the rear of your system near the
backplane, may help you. You can also try an offline diagnostic utility
such as MAPPER, or an online utility such as SYSMAP, to precisely
determine your hardware configuration. If necessary, change
NMCONFIG or contact your Hewlett-Packard Representative for
assistance in determining paths or correcting bus hardware problems.
MESSAGE: Bad hardware ID or path.
1120 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find a supported 100VG-AnyLAN or
100Base-T adapter card at the hardware path specified in NMCONFIG
(“Cause”= 32-bit hex value from a system table which holds the first
4 bytes of IODC information from the adapter card).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported 100VG-AnyLAN or 100Base-T adapter card
is installed in the computer backplane. Verify the Power LED is lit on
that adapter. If necessary, reseat the board or contact your
Hewlett-Packard Representative for hardware assistance.
MESSAGE: Adapter card found does not match software
configuration.
1130 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator found a supported adapter card at the path
specified in NMCONFIG, but it was not the right type of card for the
link being started.