NS3000/iX Error Messages Reference Manual (36923-90041)

20 Chapter1
CIERR Error Messages
ACTION: Correct the LOG option and reissue the command.
MESSAGE: INTERNAL DS ERROR — COULD NOT SEND CONTROL
MESSAGE.
5060 CAUSE: The port message with the NSCONTROL information could not
be sent from the CI to the DSDAD process.
ACTION: See “Submitting an SR” in appendix A of this manual.
MESSAGE: DSDAD.NET.SYS DOES NOT EXIST.
5061 CAUSE: The DSDAD.NET.SYS program file is missing.
ACTION: Restore the DSDAD.NET.SYS file from the NS product tape.
MESSAGE: INVALID CONTROL OPTION.
5062 CAUSE: This CI error is returned for errors detected during the
processing of an NSCONTROL command. One or more DS errors will
accompany this CI error to more fully describe the error or errors.
ACTION: Correct the error, based on the DS error(s), and reissue the
command.
MESSAGE: INVALID SERVER PIN.
5063 CAUSE: The server process ID number (PIN) in a DEBUG option in an
NSCONTROL command is not numeric.
ACTION: Correct the PIN and reissue the command.
MESSAGE: PROMPT MUST BE 8 CHARACTERS OR LESS.
5064 CAUSE: The prompt string in a DSLINE PROMPT option is longer than
the maximum of 8 characters.
ACTION: Shorten the prompt string and reissue the command.
MESSAGE: LOGON MUST BE 54 CHARACTERS OR LESS.
5065 CAUSE: The logon string in a DSLINE LOGON option is longer than the
maximum of 54 characters.
ACTION: Shorten the logon string and reissue the command.
MESSAGE: INTERNAL ERROR — DSLINE JCW NOT FOUND.
5067 CAUSE: The DSLINE Job Control Word, set to the DSLINE number by
the DS software, could not be found.
ACTION: See “Submitting an SR” in appendix A of this manual.
MESSAGE: ABORT DOES NOT ACCEPT ANY PARAMETERS.
5072 CAUSE: Parameters were specified for an NSCONTROL ABORT option.
ACTION: Delete the parameters and reissue the command.