NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 16 199
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
MESSAGE: Bad message for current state.
239 ($EE) CAUSE: This is a generic error, reported when the driver received a
request from outside when the driver was not in a state where it could
process that type of request, or the when driver has already processed a
message of this type and was not expecting another. The driver may
have encountered a previous fatal error, may be in the middle of
startup, shutdown, or a recovery or dump operation, a message may
have arrived too late, or the sender may be confused.
ACTION: If the message has replies, the driver will attempt to send an
error reply back to the sender. If another error has already occurred,
this event may be ignored. Otherwise, if the problem happens
frequently, or if external subsystems are noticeably impacted after the
error, see Appendix A, “Submitting an SR.”
MESSAGE: Unknown file record format.
240 ($F0) CAUSE: The trace or log formatter attempted to decode a record header
to obtain basic information such as length and version, but on
inspection found that the record does not appear to be a
100VG-AnyLAN or 100Base-T record supported by this formatter.
ACTION: The formatter will attempt to print this record in raw form.
You may be trying to format a trace or log file taken on a different
system that has newer software than the system you are formatting on.
Format the file on the system you took the trace or log on, or contact
your Hewlett-Packard Representative to check if VGFOS patches are
already available to update the software on your current system.
MESSAGE: Unknown data version.
243 ($F3) CAUSE: The trace or log formatter attempted to decode a record header
to obtain general information such as link type and link name, but on
inspection found that the version of that data was not supported by this
formatter, thus no other fields could be decoded.
ACTION: The formatter will attempt to print this record in raw form.
You may be trying to format a trace or log file taken on a different
system that has newer software than the system you are formatting on.
Format the file on the system you took the trace or log on, or contact
your Hewlett-Packard Representative to check if VGFOS patches are
already available to update the software on your current system.
MESSAGE: Error encountered while decoding an entry.
244 ($F4) CAUSE: The trace or log formatter encountered an entry having an
unrecognized entry tag value. The formatter cannot decode entries of
this type.
ACTION: The formatter will attempt to print this entry in raw form.
You may be trying to format a trace or log file taken on a different
system that has newer software than the system you are formatting on.