NS3000/iX Error Messages Reference Manual (36923-90041)

190 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
MESSAGE: Timeout while awaiting a link training transmit interrupt.
163 ($A3) CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
received a training frame from the 100VG-AnyLAN hub in response to
a previous send, but no interrupt arrived for the last frame it sent
within the 2 ms time allowed.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try replacing the cable
and/or adapter card.
MESSAGE: Timeout while awaiting a link training receive.
164 ($A4) CAUSE: After successfully sending a training frame to the
100VG-AnyLAN hub, no frames were received back from the hub
within the 50 ms time allowed. The hub should return one frame for
every frame sent.
ACTION: This error is informational only. The driver will retry the
connect. If the problem persists, try reducing the CPU load. The hub
sent a training idle signal, but it is not responding to frames sent to it
by the link driver. Make sure the link’s NMCONFIG configuration is
not forcing use of a MAC address already in use by some other link; in
this case the hub may not respond. Try replacing the cable and/or
adapter card. Check the hub port configuration.
MESSAGE: Timeout while awaiting any link training interrupt.
165 ($A5) CAUSE: During a 100VG-AnyLAN link connect attempt, the driver sent
a training frame to the 100VG-AnyLAN hub, but no interrupt arrived
within the 50 ms time allowed, for either the frame which was sent, or a
receive from the hub in response to it.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try replacing the cable
and/or adapter card.
MESSAGE: Hub did not report link up within time allowed.
170 ($AA) CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
exchanged 24 training frames with the hub, but afterward the LINK
signal still did not appear within the 4 ms time allowed. The hub may
not have liked some or all of the frames, although it responded anyway.
If this error is logged, it is because the link did not connect within 25 to
30 seconds after it was instructed to do so.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try checking the hub port
configuration, or replacing the cable and/or adapter card.
MESSAGE: Hub did not send link training idles within time allowed.
171 ($AB) CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
requested a training idle signal from the 100VG-AnyLAN hub, but no
idles arrived within the 400 ms time allowed.