NS3000/iX Error Messages Reference Manual (36923-90041)

166 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Generic Status Values
MESSAGE: Remote link has disconnected.
46 ($2E) CAUSE: For the Disconnect Event, the remote link station issued a
Disconnect command to the link station, and the link station has
replied that disconnect command and notified the subsystem.
ACTION: According to the subsystem.
MESSAGE: Link disconnected, although remote has not
acknowledged.
47 ($2F) CAUSE: The driver issued a disconnect command to the remote link
station as a result of receiving a Disconnect Request. No
acknowledgment has bee received from the remote link station and the
in station has been closed.
ACTION: According to the subsystem.
MESSAGE: An active connection with the remote link already exists.
48 ($30) CAUSE: The Driver is already configured.
ACTION: According to the subsystem.
MESSAGE: Link sharing conflicts with current usage.
81 ($51) CAUSE:
• A driver is being exclusively accessed by a subsystem already, no
resources have been allocated for the second subsystem.
• A subsystem wants to have exclusive access to a “shared” driver
which is currently in use, no resources have been allocated.
• Driver does not support link sharing.
• Configurable parameters conflict.
ACTION: According to the subsystem.
MESSAGE: Configuration file access error.
82 ($52) CAUSE: A module Configurator/Deconfigurator detected an error in the
configuration file on accessing the configuration file.
ACTION: According to the subsystem.
MESSAGE: Error in interface with Link Support Services.
83 ($53) CAUSE: A module Configurator/Deconfigurator failed in calling Link
Support Services (LSS) procedures.
ACTION: According to the subsystem.