NS3000/iX Error Messages Reference Manual (36923-90041)

162 Chapter15
LAN, LAN/Console, Token Ring LAN Error Messages
MESSAGE: Could not receive config reply message.
249 CAUSE: An internal system ports problem has occurred.
ACTION: Write down the error information displayed on the console
and call your Hewlett-Packard representative.
MESSAGE: Timeout waiting for the config reply message.
250 CAUSE: The link software or the card could not be configured.
ACTION: Write down the error information displayed on the console
and call your Hewlett-Packard representative.
MESSAGE: Driver’s PDA is corrupted.
251 CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an SR, take a dump and call your Hewlett-Packard
representative.
MESSAGE: Configuration of the dump manager failed.
252 CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console
and call your Hewlett-Packard representative.
MESSAGE: The link type is not LAN.
253 CAUSE: The link name type in NMCONFIG.PUB.SYS is not set to LAN.
ACTION: Use NMMGR to correct the link name type.
MESSAGE: The link driver failed to start.
254 CAUSE: Incorrect physical path was specified in the NMCONFIG file.
ACTION: Correct the physical path in the NMCONFIG file using
NMMGR.