NS3000/iX Error Messages Reference Manual (36923-90041)

16 Chapter1
CIERR Error Messages
MESSAGE: INTERNAL DS ERROR — COULD NOT GET PORT DST.
5032 CAUSE: A port data segment entry could not be allocated for the port
between the CI and the Virtual Terminal server.
ACTION: See “Submitting an SR” in appendix A of this manual.
MESSAGE: INTERNAL DS ERROR — COULD NOT START VT.
5033 CAUSE: The Virtual Terminal service could not be initiated.
ACTION: See “Submitting an SR” in appendix A of this manual.
MESSAGE: INTERNAL DS ERROR — RECEIVED BAD PORT
MESSAGE.
5034 CAUSE: A port message with an unexpected function code was received
from the Virtual Terminal server process.
ACTION: See “Submitting an SR” in appendix A of this manual.
MESSAGE: VT SERVER NOT AVAILABLE NOW.
5035 CAUSE: The Virtual Terminal server process could not be created.
There may be several reasons:
1. The DSSERVER.NET.SYS program is missing.
2. The number of created DSSERVER processes is at the allowed
maximum. The NSCONTROL SHOW=SERVERS command will tell you
the current and maximum number of DSSERVERs.
3. The DSSERVER process aborted during its initialization.
ACTION: Depending on the cause:
1. Restore the DSSERVER.NET.SYS program from the NS/3000 product
tape.
2. Wait for the number of DSSERVERs to decrease, or increase the
maximum number of DSSERVERs by NSCONTROL
SERVER=DSSERVER,,new max> (Only users with NM capability
can use the NSCONTROL command.)
3. See “Submitting an SR” in appendix A of this manual.
MESSAGE: LOCAL VT SERVICE HAS NOT BEEN STARTED.
5036 CAUSE: The local Virtual Terminal service (VTL) has not been started
using the NSCONTROL command.
ACTION: Issue either an NSCONTROL START or an NSCONTROL
START=VTL command to start the local VT service, or wait until the
service is started. (Only users with NM capability can use the
NSCONTROL command.)